[RS] Renewing brake pads - rear brake
•
Lever off cap from brake caliper.
•
Drive out retaining pins (1), working from the
wheel side.
•
Lift brake pads upwards to remove.
•
Install in the reverse order of work.
•
If necessary, push pistons fully back with reset-
ting tool, BMW No. 34 1 500.
[GS/R/RT] Renewing brake pads - rear
brake
1
•
[RT] Take out the rear wheel.
•
Unfasten/remove brake caliper.
•
Remove keeper from retaining pin (1).
•
Drive out retaining pin (1) towards the wheel side.
•
Remove brake pads.
•
Before installing the brake caliper, depress the
piston fully.
•
Install in the reverse order of work.
X
Tightening torque:
Brake caliper at rear wheel drive: ................. 40 Nm
Checking brake discs for wear
1
LT000120
•
Carefully inspect brake discs for cracking, dam-
age, distortion, wear and scoring.
Brake disc wear limit:................ 4.5 mm (0.177 in)
[RS] rear:.................................... 4.6 mm (0.181 in)
Checking brake fluid level/topping
up
(Inspection III)
Max.
Min.
GS000400
•
Remove reservoir cover together with dia-
phragm.
•
Add brake fluid up to the MAX mark.
•
Fit diaphragm and reservoir cover.
•
Carefully tighten retaining screws.
Brake fluid grade:
Use only brake fluid of DOT 4 quality classification
(e.g. ATE "SL" brake fluid)
LT000110
Max.
Min.
RS000160
00.33