Checking brake pads and discs for
wear/replacing
(Inspections II and III)
Checking brake pads for wear
Brake pads, front brake
•
Visually inspect the brake pads.
–
Wear indicators (1) must be clearly visible.
•
If necessary, check/measure thickness of brake
pads.
e
Attention:
Do not permit brake pad thickness to fall below the min-
imum value. Always replace the brake pads as a
complete set.
Minimum pad thickness: ......... 1.0 mm (0.0393 in)
•
Check that colour codes of brake pads and
brake calipers (2) match.
Colour code: ................................................. white
Brake pads, rear brake
1
2
•
Visually inspect the brake pads.
–
Make sure that the brake disc is not visible
through the bore (arrow) in the inner brake pad.
•
If necessary, check/measure thickness of brake
pads.
R22000160
e
Do not permit brake pad thickness to fall below the min-
imum value. Always replace the brake pads as a com-
plete set.
Minimum pad thickness: ........ 1.0 mm (0.0393 in)
–
If the brake disc is visible through the bore in the
wheel-side brake pad, the brake lining is worn to
its minimum permissible thickness.
Attention:
R22000170
00.37