[ABS] Adjusting front sensor gap
Marking sensor wheel
•
Take load off front wheel/lift clear of ground.
•
Attach dial gauge holder (1), BMW No. 00 2 500,
with dial gauge, BMW No. 00 2 510 and meas-
uring shoe (2), BMW No. 34 2 510, to fork slider
tube.
•
Zero the dial gauge.
•
Measure axial runout over the entire circum-
ference.
•
Using a paint pencil, make a permanent mark at
the point where the sensor is farthest away from
the sensor wheel (arrow).
e
Caution:
If parts are replaced (brake disc etc.) and a used or
previously marked sensor wheel is installed, the
sensor ring must be measured and marked again.
Remove the old marking.
00 2 510
34 2 510
00 5 500
Checking and adjusting sensor gap
•
Check/adjust at the marked point.
•
If necessary, remove/install sensor with
Torx T 25 and adjust sensor gap with spacing
plates.
Sensor gap:.. 0.45...0.55 mm (0.0177...0.02165 in)
e
Caution:
After adjusting, check that the sensor wheel is free
to turn at all points on its circumference.
2
1
RS340100
34.19