Setting A Secondary Keypad (Controller); Updating Keypads (Controllers) With New Or Removed Devices - Honeywell Tuxedo User Manual

ICON
3. Press GO.
4. Select the device(s) to be enabled in this
group and press the Save icon.
5. Press the Edit icon to rename the room.
Group Setup Icons
Edit
Delete

Setting a Secondary Keypad (Controller)

After all Z-Wave devices have been included into the Primary Keypad (Controller #1), the device information can be downloaded
to a Secondary Keypad (Controller #2). Keep controllers within 10 feet of eachother, apply power to Controller #2 and do the
following:
ICON
1. At Controller #1:
a) Press the Automation icon from the "Home"
screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
2. At Controller #2:
a) Remove any Z-Wave devices that have been
added.
b) Press the Z-Wave Primary icon (located in
the lower right side of the screen).
c) Select Yes to change this keypad to a
Secondary Controller.
3. At Controller #1:
a) Press Add.
4. At Controller #2:
b) Press Add.

Updating Keypads (Controllers) with New or Removed devices

When devices are added or removed from the Z-Wave network, the device information needs to be updated in the Keypads
(Controllers). To update this information, from the Primary Keypad, do the following.
ICON
1. Press Add on Primary controller.
2. Press Add on Secondary controller.
Automation (cont'd)
ACTION
Add Save
ACTION
ACTION
NOTES
• Press the ABC/.?123 key to switch between numerals and
symbols/characters.
• Press GO to return to the "Add New Camera" screen.
If settings were changed, a pop-up window displays: Settings saved. Select
OK to save.
NOTES
If used for Remote Services, Tuxedo WiFi should not be configured as a
secondary controller. See the Remote Services section.
Note: Up to 232 Secondary Controllers can be added.
The message is displayed:
"Please remove all Z-wave devices from network first"
The message is displayed: "Scanning for Devices"
The message is displayed: "Updating Devices. Please Wait".
When the device information from the Primary Controller is downloaded to
the Secondary Controller:
• the Secondary Controller displays, "Controller Add Success".
• the Primary Controller displays, "Device Added Successfully".
NOTES
The controller scans for device changes.
The message is displayed: "Devices added Successfully"
40