Mcp1 Card (Only Use In The Officeserv 100 System); Figure 3.14 Mcp1 Card - Samsung OfficeServ 100 Installation Manual

3.16 MCP1 Card (only use in the OfficeServ 100
system)
MCP1(The Main Control Processor 1) card is the main processor card with a 32 bit
processor, and controls the overall operation of the OfficeServ1500 system. MCP1 card is
mounted on the MEM slot of the OfficeServ 100 basic cabinet. Push in middle of the
MCP1 card to ensure that it is fully inserted into the back plane connector.
To prevent accidental damage to MCP1 card, the connector on the back plane is positioned
to mate only with the MEM(MCP1) card. Other interface cards will not mate with this
connector and MEM cards will not mate with any other connector.
Supported with RJ45 LAN Interface, DB9 SIO Connecter and IPC(Inter Processor
Communication) with SP(68EC000 in the 008Base Board).
Support with most of current iDCS 100(DCS Compact II) cards.
Include new MISC 3(4), MGI3 and 4WLI cards & other cards, except MISC 1/2, ITM3
Cards.
The procedures for mounting and connecting connectors, LED indicator, memory back-up
ON/OFF switch, and only used 500 MDOEM optional d-board and 3 pin cable connected
the MCP1 board for MP serial data(TXD, RXD, GND) signaling to the 500 MODEM.
© SAMSUNG Electronics Co., Ltd.

Figure 3.14 MCP1 Card

OfficeServ 100 Installation Manual/Ed.00
3-15