Samsung OfficeServ 100 Installation Manual page 106

CHAPTER 10. Networking Description and Programming Procedure
DND & DND Override
When a networking call is received, but the destination station is DND, first the
disconnection message will be sent back to the origination station. At this time, the
message will be 'busy'.
Then, the origination system receives this message and sends the agreement message
to disconnect the call. And, the origination station sends a 'busy tone' so that the other
party can know that the station is busy. To terminate the call after giving DND tone for
the set time, the 'DND tone' option in Program 823 shall be set to 'Y'.
When the station of another system is called, the DND tone is heard and DND status is
indicated, the DND can be overridden. The 'DNDO' option of Program 823 is set to
'Y', and the 'DNDO CAPABL' option number of the origination station shall be
bigger than the 'DNDO PROTECT' option number of the DND set station. If the
option numbers are same, this function will not operate.
This function operates only when the 'TRK INC.DND' option of Program 400 is 'On'.
Path Replacement
When the networking call is connected, you can press the PTHR button to replace a new path.
The 'PATH REPL. ' option of Program 823 shall be set to 'Y'.
Centralized Voice Mail
To have only one SVMi card installed in network and share with other systems, the
following items shall be set:
The SVMi card shall create voice mail for each station. The voice mail uses the
commands exclusively used for the SVMi card or can be automatically created by
setting the 'MB' option of Program 824 to 'Y'. It is recommended to change the
unused voice mail with the commands of SVMi card even after the voice mail is
automatically created.
The station number assignments shall not be duplicated because the voice mail system
is based on the station or station group numbers.
If there is no SVMi card in the system, the VMMSG button is pressed to connect the
voice mail directly. The 'Use Remote VM' option of Program 825 shall be set to 'Yes',
and the station number to connect the voice mail shall be set in the 'Remote VM
Number' option.
When the trunk line call is received and the caller ID is to be sent to another system,
the node number shall be added in the front. In order to remove this added node
number when sending the caller ID to the voice mail, the 'Remote CID Number'
option of Program 825 shall be set to 'Yes'.
10-14 © SAMSUNG Electronics Co., Ltd.