Samsung OfficeServ 100 Installation Manual page 102

CHAPTER 10. Networking Description and Programming Procedure
Program 711. Auto Route Selection Time
Four time zones are assigned for each weekday when using auto route selection.
Fields of the program are described below.
SUN~SAT: Displays weekdays from Sunday to Saturday.
A~D: Displays the four time zones. Enter all 24 hours into time zone A since cost
differences between service providers are seldom inversed in Korea.(e.g., A: 0000, B:
2359)
HHMM: Enters the hours and minutes in the 24 hour mode.
LCRT: Sets the number of the time table used in Program 712. Set all numbers as 1 for
Korea.
Program 712. Auto Route Selection Route
This program allows you to set the routing table for trunk line selection when using the
Auto Route Selection feature.
Fields of the program are described below.
(01~32): Index number representing up to 32 routes.
(1~4): The number of the time table set in Program 711. Set all numbers as 1 for Korea.
C: The Auto Route Selection class number set in Program 310.
G: Assigns the trunk line group number.
M: Enters the Dial Conversion Table number in Program 713 when digit conversion is
required for outgoing calls.
VoIP networking is generally used. However, if you wish to use PRI networking only
when VoIP signaling trunk line is all busy or when the Internet network cannot support
VoIP calls, the class of Program 310 shall be set as 2 or higher, and 'C:1 G:801' and
'C:2 G:802' shall be set. In this case, 801 represents the VoIP signaling trunk line
group, and 802 represents the networking PRI trunk line group.
Program 713. Convert Auto Route Selection Digit
This program is used when digit conversion is required for final outgoing trunk line calls
when using the Auto Route Selection feature. Fields of the program are described below.
(001~200): Index numbers of the digit conversion table.
NOF DEL DGT: Sets the number of digits to be deleted starting from the first digit
when deleting a portion of the dialed number. Only the forepart, not the middle or rear
part of the digit may be deleted.
I: Inserts digit used to add digits in front of the dialed number.
A: Appends digit used to add digits in the rear part of the dialed number.
10-10 © SAMSUNG Electronics Co., Ltd.