Andrew ES45T Installation, Operation And Maintenance Manual page 64

ES45T-T Reflector Assembly
Step 6
Determine required length of azimuth strut to nearest degree increment of desired
azimuth setting. Adjust coarse azimuth setting by withdrawing secondary strut section
from primary strut to achieve desired strut length. Install four 1/2 inch (13 mm) set
screws in holes provided and securely tighten. Note: Do not extend secondary strut
section into red warning area.
Step 7
Carefully pivot reflector as required and attach azimuth strut to U-bracket using previ-
ously removed 3/4 x 4-1/2 inch (114 mm) bolt, lockwasher and nut. Note: Apply grease
(P/N 49208) around bottom area of lower azimuth axis joint assembly (P/N 49629)
before changing azimuth position of antenna.
Step 8
Fine Adjustment. Attach fine adjustment assembly between adjacent elevation strut
sections as shown in Figure 76 using appropriate brackets, U-bolts, brass hex nuts, flat-
washers and threaded rod. Securely tighten all adjustment assembly hardware. Note:
Adjustment assembly may also be attached in alternate position shown depending on
required elevation angle.
Step 9
Attach fine adjustment assembly between adjacent azimuth strut sections as shown in
Figure 77 using appropriate brackets, U-bolts, brass hex nuts, flatwashers and threaded
rod. Securely tighten all adjustment assembly hardware. Note: Fine adjustment assem-
bly on azimuth strut should be positioned away from ground mount angles.
Figure 76
Figure 77
64
Installation Procedures