Andrew ES45T Installation, Operation And Maintenance Manual page 56

ES45T-T Reflector Assembly
Step 2
Loosely attach tee plates (P/N 202447) and corresponding rib connecting plates (P/N
202444) to points B, C, D, E, and F.
•
Use A-325 ½ x 1-¼ in. bolts, flatwashers and nuts. (see page 12)
•
Insert bolts from concave side of reflector
CAUTION: Do not install A-325 ½ x 1-¼ in. hardware in center hole of rib connecting
plates (P/N 202444) at positions B, D, or F only.
Step 3
Loosely assemble two support angles (P/N 49438) to pivot bracket (P/N 300758). Attach
opposite ends of support angles to tee plates (P/N 202447) at points A and E.
•
Angle should be installed with edge up and flat of angle toward reflector
Step 4
Loosely attach support angle (P/N 49436) from tee plate at F to pivot bracket (P/N
300758).
•
Angle should be installed edge down with flat of angle away from reflector
Step 5
Loosely assemble two support angles (P/N 49438) to pivot bracket (P/N 300745). Attach
opposite ends of support angles to tee plates (P/N 202447) at points A and C.
•
Angles should be installed edge up with flat of angle toward reflector.
Step 6
Loosely attach support angle (P/N 49436) between tee plate at point B and pivot brack-
et (P/N 300745).
•
Angle should be installed edge down with flat of angle away from reflector
Step 7
Loosely attach support angle (P/N 49437) between pivot brackets (P/N 300745/300758).
•
Angle should be installed edge down with flat of angle away from reflector
Step 8
Loosely assemble support angles (P/N 49438) to elevation axis bracket (P/N 49429-2).
Attach opposite ends of support angles to tee plates at points C and E.
•
Angles should be installed edge up with flat of angle toward reflector
Step 9
Loosely attach support angle (P/N 49436) between tee plate at point D and elevation
axis bracket (P/N 49429-2).
•
Angle should be installed edge down with flat of angle away from reflector
Step 10
Loosely attach support angles (P/N 49437) between elevation axis bracket and the two
pivot brackets.
•
Angles should be installed edge down with flat side away from reflector
56
Installation Procedures