Es45T-T Reflector - Andrew ES45T Installation, Operation And Maintenance Manual

ES45T-T-1
The ES45T-T-1 reflector is composed of six precision-formed panels designed for accu-
Reflector
rate strength, and ensures a reliable surface contour that provides exceptional operating
characteristics in C-, X- or Ku-frequency bands.
Step 1
Reflector should be assembled on a clear, flat area in front of the foundation pad. Clear
debris from area and place plastic sheeting from packing crate as shown in Figure 56.
Step 2
Arrange diameter setting band assembly (P/N 49612) and temporary supports as shown
in Figure 54.
•
Tighten ¼-20 hardware at center connection until snug
•
Reflector should be assembled in front of foundation pad with bottom of reflector 3 ft.
from pad
•
Temporary supports should be 6-8 in. high
•
Tie three string levels to opposing blocks across diameter of circle
•
Adjust supports with shims until strings are level and lightly touch at center of circle
•
Once supports are level, remove strings
•
Move supports 12 in. radially away from circle, carefully maintaining orientation and
height for later reuse
ES45T-T Reflector Assembly
46
Figure 54
Installation Procedures