Canon iPF9000S Troubleshooting Manual page 64

Panel display
Code
(last 4
Large LCD
digits)
401E ERROR
E198-401E
Call for service.
4027 Hardware error.
03130031-4027
Turn off printer,
wait, then
turn on again.
4034 ERROR
E196-4034
Call for service.
4037 ERROR
E173-4037
Call for service.
403E ERROR
E161-403E
Call for service.
403F ERROR
E161-403F
Call for service.
4040 ERROR
E196-4040
Call for service.
4041 ERROR
E196-4041
Call for service.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
ERROR
E198-40
1E
Call For
Service
Power Lift
On Motion
Again Timeout
ERROR
E196-40
34
Call For
Service
ERROR
E173-40
37
Call For
Service
ERROR
E161-40
3E
Call For
Service
ERROR
E161-40
3F
Call For
Service
ERROR
E196-40
40
Call For
Service
ERROR
E196-40
41
Call For
Service
Explanation/Detection sequence
RTC clock stop
The RTC has been detected idle while
initializing the RTC at startup.
Lift shift timeout error
A lift operation has been executed, but no
sensor has been detected or a sensor has
remained detected.
Multisensor unit version error
A different version of multisensor is installed.
This would not occur in an ordinary user
environment.
Linear scale error
No signal is available from the carriage
encoder when the head is driven.
Head abnormal temperature rise (head 1
(R), or A model)
Either of the two Di sensors maintained for
each printhead chip (color-specific) has
o
been detected at 120 C or higher or -10
or lower.
Head abnormal temperature rise (head 2
(L))
Either of the two Di sensors maintained for
each printhead chip (color-specific) has
o
been detected at 120 C or higher or -10
or lower.
Checksum error
The checksum of a file transmitted on
execution of the firmware update is
unmatched.
Flash erase error
Failed to erase flash ROM on execution of
the firmware update.
2-52
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Restart the
printer in
service mode.
②Replace the
main PCB.
①Switch off the
printer, then
back on.
②The carriage
cannot travel
to the lift drive
position.
③The lift drive
cam is not
engaged.
④Faulty lift drive
sensor
⑤Faulty lift drive
motor
Go to ★
4027(P3-22).
①Replace the
multisensor
unit.
Go to ★2F26
(P3-4).
Go to ★
403E(P3-21).
o
C
Go to ★
403E(P3-21).
o
C
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Replace the
main PCB.
①Start in
download
mode to
upgrade the
firmware.
②Restart the
printer in
service mode
to clear the
error.
③Replace the
main PCB.