T11 Ink Supply System Fault Isolation Tool - Canon iPF9000S Troubleshooting Manual

T11 Ink Supply System Fault Isolation Tool

Can be checked without removing the outer covering
Pull out the carriage
T14
Cannot be checked without removing the outer covering
Check the carriage position on capping
Lower the cap and check its gap from
the head
Check the tube at the position not
visible above
Photo 1
iPF5000 Series
About 8 mm
Photo 3
About 2 mm
Check the tube for ink
Check to see if the head ink supply
joint is properly connected
Check to see if foreign matter is
not stuck in the purge cap and
wiper
A gap of about 8 mm
(Photo 1)
Parallel with a gap of 2 mm
(Photo 3)
Sufficient ink left
Little or no ink left
Photo 2
Chapter 5 Fault Isolation Tool Collection
Little or no ink left
Properly connected (check
also for lever cracks)
Remove the foreign matter
2F26
Flow 1
Flow 2
Adjacent three colors
T02
Else
Other than iPF5000 Series
About 8 mm
4-15
Adjacent
Flow 1
three colors
Purge fault isolation
T02
Else Flow 2
Air leak isolation
iPF5000 Series: Photo 1
Other than iPF5000 Series: Photo 2
Purge fault isolation
Air leak isolation
Flow 1
Purge fault isolation
Flow 2
Air leak isolation