Canon iPF9000S Troubleshooting Manual page 47

Panel display
Code
(last 4
Large LCD
digits)
2E0B Cassette printing
is selected.
Press Load/Eject
and
remove manually
loaded sheets.
2E0C Manual printing
is selected, but a
roll is loaded.
Press Load/Eject
and
remove the roll.
Sheet printing
is selected, but
a roll is loaded.
Stop Printing
Sheet printing
is selected, but
a roll is loaded.
2E0E No Roll Feed Unit.
Turn printer off
and install roll
feed unit.
2E0F Top cover is open.
Turn off printer,
wait a while, and
turn it on again.
2E10 Ink tank cover
is open.
Turn off printer,
wait a while, and
turn it on again.
2E11 Carriage Cover is
open.
2E12 Rel lever is in
wrong position.
Turn off printer,
wait, then
turn on again.
2E14 Wrong paper size.
Check paper size
setting on computer.
Online: Print
Stop: Stop Printing
Wrong paper size.
Check paper size
setting in driver.
Online: Print
Stop: Stop Printing
Small LCD Small
1 LCD 2
Sheets Cassette
Loaded Selectd
Press ↓ Load
To Eject Papr in
Cas
Tray Paper mismatch (cut sheet)
Selected ① Print data having a manual feed print
Press OK
②Print data having a manual feed print
③Cut sheet data has been received when
Roll P Power
Unit On
Please Again
Check
Top Cover Top
Please Cover
Close Open
Close
Top
Cover
Ink Tank Tank
Cover Cover
Close Open
Please Close
Please
PaprSiz Loaded
Mismatch Papr Diff
Prnt:Pres From
sOnline Spfd
Size
Driver: Loaded
Chk Papr Papr Diff
Size From
Setting Spfd
Size
Explanation/Detection sequence
Paper mismatch (cut sheet)
Print data having a cassette print
specification has been received at the
completion of manual feed paper pickup.
specification has been received at the
completion of roll paper pickup.
specification has been received when
there is roll paper printout.
the media take-up unit is in use.
Roll paper unit not installed
The unit has received print data having a roll
paper print specification when it had started
without a roll unit being connected to it.
The top cover is abnormally open.
Ink tank cover error open (continued use
allowed)
The ink tank cover opened while performing
any operation, such as printing and
suctioning.
Carriage cover open error
A carriage cover open has been detected.
Faulty release lever
The state of the release lever up (released)
has been detected.
Paper mismatch (size or width)
The paper size specified for the [Print to
meet the paper width] setting of the driver on
receiving print data and the width of the roll
paper actually fed did not match.
2-35
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Check the paper
that is actually
loaded on the
paper and the
paper feed
setting of the
driver.
Check the paper
that is actually
loaded on the
paper and the
paper feed setting
of the driver.
①Check the roll
unit, and
remove, install
or replace the
roll unit.
②Check IO mode
(roll unit
detection).
Check the cover.
Check the sensor
(IO mode).
Close the ink tank
cover.
Check the sensor
(IO mode).
Close the
carriage cover.
Check the sensor
(IO mode).
Push down the
release lever.
Check the
sensor.
Check the paper
that is actually
loaded on the
printer and the
paper size setting
of the driver.
Go to ★2010
（P3-12）