Canon iPF9000S Troubleshooting Manual page 29

Panel display
Code
(last 4
Large LCD
digits)
2407 Borderless printng
not possible. Paper
stretched or shrank.
Confirm usage cond.
of the paper.
2408 Borderless printng
not possible. Check
supported paper.
Bordless Printing
not possible. Lift
release lever and
reload the paper.
2409 Paper position not
suitable for
borderless printing.
240A Borderless printng
not possible. Check
supported paper.
Small Small
LCD 1 LCD 2
It occurs when all of the following conditions
are met at start of printing.
・Borderless printing data has been received.
・Roll paper has been loaded, and its paper
width and edge position recognized at
loading are within the supported range of
borderless printing.
・As a result of right/left side edge detection
after start of print processing, it was
detected as beyond the supported range of
borderless printing.
At the start of borderless printing, roll paper
whose size doesn't support borderless
printing has been loaded.
Invalid paper loading position (suspended
job/ borderless printing)
All of the following conditions were met.
・Borderless printing data has been received.
・Roll paper whose paper loading position is
not suitable for borderless printing has been
loaded.
・The right or left edge of roll paper is more
than 1mm off the prescribed position of the
pre-ejection opening.
Borderless printing is not possible
(suspended job/ unsupported size). All of the
following conditions are met.
・Borderless printing data has been received.
・Roll paper not supporting borderless
printing has been loaded.
2-17
Explanation/Detection sequence
Chapter 2 Indexes by Case
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Reset /replace the
roll paper.
Confirm and
explain usage
environment.
Replace with
appropriate paper.
Reload/ replace
the roll paper.
Go to ★2010
(P3-12).
Check the roll
paper.