Canon iPF9000S Troubleshooting Manual page 32

Panel display
Code
(last 4
Large LCD
digits)
2590 Ink insufficient.
to Press OK and
259C replace ink tank.
Ink insufficient.
Replace ink tank.
25B7 Close the ink tank
cover. Unable to
detect
ink level correctly
Unable to detect
ink level correctly
260E Hardware error.
03130031-260E
Turn off printer,
wait, then
turn on again.
260F Gap error.
Turn off printer.
2618 Hardware error.
03130031-2618
Turn off printer,
wait, then
turn on again.
Troubleshooting Guide
Small Small
LCD 1 LCD 2
Not Replace
Enough ink tank
Ink orOnline
↓↓↓ to prnt
↓↓↓
Power Gap
On Detect
Again Err
Power On Gap
Again Error
Explanation/Detection sequence
Ink tank short on ink
A print operation was attempted, but there is
not enough ink left in the tank for the
operation.
(In the small LCD, the arrow ↓ points to the
color in question.)
Reference)
About 5 mL to 40 mL of ink may have been left in the tank when
this warning occurs.
The remaining ink falls below the pin check
level while ink tank cover is open.
Gap detection failure
Carriage gap calibration has not been
carried out, or gap detection is disabled by
corrupt calibration data.
Gap reference plane error
Request to replace an abnormal reference
plane sheet (only in Service mode).
Vh voltage error
2-20
Remedial Action
(★: Reference fault
isolation procedure
or tool)
①Replace the ink.
②Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)
Close the ink tank
cover.
Note) It doesn't
recover if the
cover is open
when replacing
the ink tank with a
valid one.
①Check to see if
the
multisensor
reference
plate (white
patch for batch
correction) is
not soiled and
perform GAP
CALIB (if
soiled, adjust
the part after
replacing it).
②Replace the
multisensor
and perform
GAP CALIB.
③Replace the
carriage unit
and perform
GAP CALIB.
Check the
multisensor
reference plate
(for soiling and
faulty mounting).
Go to Flow 1 in ★
2010 (P3-12)
Go to ⑩ (all
nozzles on a
single- or
double-head
model not
discharging) in
★T03 (P4-3).