Table of Contents
Advertisement
A Error Messages and Indicators
The board reports POST errors in three ways:
•
By sounding a beep code
•
By lighting the diagnostic LEDs
•
By displaying an error message on the monitor
BIOS Beep Codes
The BIOS beep codes are listed in Table 31. The BIOS also issues a beep code (one long tone
followed by two short tones) during POST if the video configuration fails (a faulty video card or
no card installed) or if an external ROM module does not properly checksum to zero.
Table 31.
Beep Codes
Number of Beeps
1
2
3
4
5
6
7
8
9
10
11
Description
Refresh failure
Parity cannot be reset
First 64 K memory failure
Timer not operational
Processor failure (Reserved; not used)
8042 GateA20 cannot be toggled (memory failure or not present)
Exception interrupt error
Display memory R/W error
(Reserved; not used)
CMOS Shutdown register test error
Invalid BIOS (such as, POST module not found)
73
Hide quick links:
Advertisement
Table of Contents
