Installing The Desktop Board; Location Of The Mounting Screw Holes - Intel D815EEA Product Manual

Installing the Desktop Board

Refer to your chassis manual for instructions on installing the desktop board. The desktop board is
secured to the chassis by seven screws. Figure 10 shows the locations of the mounting screw
holes.
✏
NOTES
You will need a Phillips (#2 bit) screwdriver.
Refer to Appendix B for regulatory requirements and installation instructions and precautions.
WARNING
Only qualified technical personnel should attempt this procedure. Disconnect the computer
from its power source before performing the procedures described here. Failure to disconnect
the power before you open the computer can result in personal injury or equipment damage.
Figure 10. Location of the Mounting Screw Holes
Installing and Replacing Desktop Board Components
OM10093
31