Boot Menu - Intel D815EEA Product Manual

Intel Desktop Board D815EEA Product Guide

Boot Menu

To access this menu, select Boot from the menu bar at the top of the screen.
Maintenance
The menu represented in Table 24 is used to set the boot features and the boot sequence.
Table 24.

Boot Menu

Feature
Quiet Boot
Quick Boot
Scan User Flash
Area
After Power
Failure
On Modem Ring
On LAN
On PME
st
1 Boot Device
nd
2 Boot Device
rd
3 Boot Device
th
4 Boot Device
th
5 Boot Device
62
Main Advanced
Options Description
• Disabled
Disabled displays normal POST messages.
• Enabled (default)
Enabled displays OEM graphic instead of POST messages.
• Disabled
Enables the computer to boot without running certain POST
tests.
• Enabled (default)
• Disabled (default)
Enables the BIOS to scan the flash memory for user binary
files that are executed at boot time.
• Enabled
• Stays Off
Specifies the mode of operation if an AC power loss occurs.
• Last State (default)
Power On restores power to the computer.
• Power On
Stay Off keeps the power off until the power button is pressed.
Last State restores the previous power state before power
loss occurred.
• Stay Off (default)
In APM mode only, specifies how the computer responds to
an incoming call on an installed modem when the power is off.
• Power-On
• Stay Off
In APM mode only, determines how the system responds to a
LAN wake up event.
• Power-On (default)
• Stay Off (default)
In APM mode only, determines how the system responds to a
PCI power management event.
• Power-On
• Floppy
Specifies the boot sequence from the available devices. To
specify boot sequence:
• ARMD-FDD
(Note 1)
1.
• ARMD-HDD
(Note 2)
2.
• IDE-HDD
(Note 3)
• ATAPI CDROM
The operating system assigns a drive letter to each boot
• Intel UNDI, PXE 2.0
device in the order listed. Changing the order of the devices
• Disabled
changes the drive lettering. The default settings for the first
through fifth boot devices are, respectively:
• Floppy
• IDE-HDD
• ATAPI CDROM
• Intel UNDI, PXE 2.0
• Disabled
Security Power
IDE Drive Configuration
Select the boot device with <↑> or <↓>.
Press <Enter> to set the selection as the intended boot
device.
Boot
Exit
continued