Removing The Agp Card Retention Mechanism; Installing And Removing Memory - Intel D815EEA Product Manual

Intel Desktop Board D815EEA Product Guide

Removing the AGP Card Retention Mechanism

CAUTION
Once removed using this method, the AGP RM cannot be reused.
Follow these instructions to remove the AGP card retention mechanism:
1. Using side-cutters (A), cut the loop (B) joining the two sides of the retention mechanism.
2. Spread the sides of the retention mechanism (C) and lift the retention mechanism off of the
AGP connector.

Installing and Removing Memory

CAUTION
To be fully compliant with all applicable Intel
DIMMs that support the Serial Presence Detect (SPD) data structure.
You can access the PC Serial Presence Detect Specification at:
http://www.intel.com/design/chipsets/memory/
The board has three 168-pin DIMM sockets arranged as banks 0, 1, and 2 as shown in Figure 8.
The memory module requirements are listed in the Main Memory section on page 10.
28
B
A
c
Figure 7. Removing the AGP Card Retention Mechanism
c
®
SDRAM memory specifications, the board requires
OM10113