Eptz3000I Dome Camera Installation - EverFocus EPTZ3000 User Manual

Notice: In order to protect the bulb from dirt and scrape, please put on the gloves before
installing the bulb.
7. Turn on the power, and start to operate the EPTZ3000.
Note: When turning on the power, EPTZ3000 will enter self-inspection mode, and carry out
a self-testing program. After finishing self-inspection, you can start to operate the
EPTZ3000.

2.4.3. EPTZ3000I Dome Camera Installation

1. Take off the housing from the packing, and take off the PCB board (4 bolts on it) inside
the housing.
2. Cut the ceiling against the housing's shape with a saw.
3. Thread the cable through the screw and the hole on the top of the housing, and tighten
up the screw to fix the cable
4. Place the housing into the hole that you just made. Fix the housing on the ceiling with
two clips, adjust the screws of clips to make the housing perfectly fit to the ceiling.
5. Connect the cable connectors to the nodes on the base board, and then fix the base
board in the housing by screwing 4 bolts on it.
2-22