Power Up Your Prestige; Figure 2-4 Connecting The Microfilter; Figure 2-5 Power-On Display - ZyXEL Communications Prestige 642 User Manual

Prestige 642 ADSL Internet Access Router
Step 1. Connect a phone cable from the wall jack to the single jack end of the Y- Connector.
Step 2. Connect a cable from the double jack end of the Y-Connector to the "wall side" of the
microfilter.
Step 3. Connect another cable from the double jack end of the Y-Connector to the Prestige.
Step 4. Connect the "phone side" of the microfilter to your telephone as shown in the following figure.
Wall
Jack
2.6

Power Up Your Prestige

At this point, you should have connected the console port, the ADSL line, the Ethernet port and the power
port to the appropriate devices or lines. You can now apply power to the Prestige by turning the switch on.
Step 1. Initial Screen
When you power on your Prestige, it performs several internal tests as well as line initialization. After the
initialization, the Prestige asks you to press ENTER to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp.
initialize ch =0, ethernet address: 00:a0:c5:01:23:45
HWSAR (FPGA) : programming (11969) ... done
HWSAR (FPGA) : testing ... done
Wan Channel init ........ done
Loading ADSL modem F/W
............................................... done
Press ENTER to continue...
Step 2. Entering Password
The login screen appears after you press ENTER, prompting you to enter the password, as shown below.
2-4
Y -CONNECTOR
Figure 2-4 Connecting the Microfilter
Figure 2-5 Power-On Display
Prestige
Microfilter
Wall Phone
Side Side
Hardware Installation & Setup