Resetting A Handset; Changing The Maintenance Password - Nortel T7406E Installation And Configuration Manual

6 Remove the power source from the base station.
7 Set the DIP switches to normal operation mode.
8
Plug the power source back into the base station.
9 Power cycle the base station.

Resetting a handset

Reset the handset to revert settings and status to their original defaults. Ensure the handset is in
standby mode before you start this procedure.
1 In System Programming mode, use the up and down softkeys to navigate to the Maintenance
menu.
2
Log in using the maintenance password
3 Press Select.
4 Use the up and down softkeys to navigate to the Reset option.
5
Select yes to reset the handset.
The Resetting ...Please Wait! message appears in the LCD.
The handset returns to default status. The handset restarts and the Initializing
...Please Wait! message appears in the LCD. The Please Register! message
appears.

Changing the maintenance password

1 Log on to the Maintenance menu using the default password (000000).
2
Use the up and down softkeys to navigate to the Change PSW option.
3 Press Select.
You are prompted to enter the new password.
4
Enter the new password.
The password must be six digits. You cannot proceed unless you enter six digits and the
system does not allow you to enter more than six digits.
5
Press Select.
You are prompted to enter the new password again.
6 Enter the new password again.
7
Press Select.
The OK! message appears, confirming that you have successfully changed the password.
Chapter 4 Registering, deregistering, and resetting handsets
T7406E Cordless Handset Installation and Configuration Guide
43