Chapter 4
Registering, deregistering, and resetting handsets
This chapter provides procedures for registering the T7406E cordless system.
Complete the following procedures in the order in which they are provided to register handsets:
•
Setting the base station DIP switches for a single-base station application
•
Setting the base station DIP switches for a two-base station application
•
Assigning a port ID to a handset
•
Registering a handset
•
Deregistering one handset
•
Deregistering all the handsets
•
Resetting a handset
•
Changing the maintenance password
Setting the base station DIP switches for a single-base station
application
Refer to
Appendix A, "DIP switch settings," on page
1
Locate the base station DIP switches at the back of the base station.
2
Set the DIP switches to normal operating mode.
Setting the base station DIP switches for a two-base station
application
If you install two base stations, and there is interference between the two when in normal operating
most, you can set one base station to operate in the band A (upper band) and the other base station
to operate in band B (lower band). For the DIP switch settings for each operating mode, refer to
Appendix A, "DIP switch settings," on page
1
Locate the base station DIP switches at the back of the first base station.
2
Set the DIP switches to normal operating mode for a two-base station application—base
station A.
3
Locate the base station DIP switches at the back of the second base station.
4
Set the DIP switches to normal operating mode for a two-base station application—base
station B.
The base stations each now operate in one half of the ISM band.
51" for the correct settings for each mode.
51.
T7406E Cordless Handset Installation and Configuration Guide
39