Table of Contents
Advertisement
7.2 Menus
The following table show the structure of the menus (but not what they look like on the screen) and
give a brief description of the meaning of each menu item.
Notes for menu descriptions
*
This command is also available from a special button on the remote control.
†
In the Color Balance menu, the up-down arrows move the highlight through the two
columns. The left-right arrows change the highlighted value.
‡
This command is available only from a special button on the remote control.
§
The numbers in this menu are for reference only; they are not measurements.
Main menu
Source Select *
Frequency *
Phase *
Input Level
Zoom
Position
Color Balance *
Curtain *
Hours
Save Config
Recall Config
Reset Config *
Misc Control
About
7 - 4
Opens a menu to select the source for either Input 1 or 2 and to select the mode of
that source.
Opens the Frequency Select menu, where the electronics module's frequency is
adjusted to the computer's frequency.
Opens the Phase Select menu, where the electronics module's phase is adjusted to
the computer's phase.
Opens the Input Level menu, the gateway to the Black Level and White Level menus.
Opens the Zoom adjustment box, where the image can be stretched or compressed
on any one of the four sides.
Opens the Position box, where the image may be moved electronically.
Opens the Color Balance menu, where the brightness and color of the displays are
matched to each other.
Opens a Curtain Select box, where the Curtain can be turned on and off. The special
Curtain button on the remote turns the Curtain on (black screen) and off without
bring up the Curtain menu.
Opens the Panel Hours box, where Panel Hours can be read and reset, and System
Hours can be read (but not reset).
Opens the Save Config(uration) box, where the current configuration can be saved.
*Also, go to this menu by pressing RESET twice.
Opens the Recall Config(uration) box, where the saved configuration can be
recalled.
*Also, go to this menu by pressing RESET three times.
Opens the Reset Config(uration) box, so the unit can be returned to the factory
default configuration.
Opens the Misc Control menu.
Opens the About box.
Advertisement
Table of Contents
