Table of Contents
Advertisement
Attention:
the lever to release the latches while you remove the cable from an LC-SC cable
adapter. Ensure that both levers on the LC-LC cable are in the released position
when you remove the cable.
1. On the end of the cable that connects into the LC connector end of the LC-SC
Figure 15. LC-LS Fibre Channel cable lever and latches
2. Carefully pull on the connector to remove it. Make sure you grasp the connector
Figure 16. Removing the LC-LC Fibre Channel cable from an LC-SC Fibre Channel cable
adapter
3. Replace the protective caps on the cable ends.
Types of interface ports
The FAStT900 Storage Server has the following types of interface ports:
v Host mini hub
v Drive mini hub
v Ethernet
The host and drive mini-hub ports are used for data transfer between hosts or drive
enclosures and RAID controllers in the FAStT900 Storage Server. Ethernet ports
are available for storage subsystem-management. The FAStT900 Storage Server
To avoid damaging the LC-LC cable, make sure you press and hold
cable adapter, press down and hold the lever to release the latches. Figure 15
shows the location of the lever and latches.
and not the cable when you remove the LC-LC cable from the LC-SC cable
adapter, as shown in Figure 16.
11
Chapter 1. Introduction
Advertisement
Table of Contents
