Maintenance; Maintenance Schedule - Jonsered FR2211R Operator's Manual

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.

Maintenance

Cleaning
Check the engine's oil level
Check the engine's cooling air intake
Check the fuel pump air filter
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage
Clean around the silencer
Check the muffler
1)
Change engine oil
Replace the air filter's prefilter2)
Check the cutting deck
Check the air pressure in the tyres, 60 kPa/8.5 PSI.
Lubricate the belt adjuster
Lubricate joints and shafts
Adjust the brakes FR 2211 R and FR 2211 M
Check the V-belts
Check the transmission's cooling fins, FR2213MA, FR2216A, FR2216A2
Checking the oil level in the transmission on FR2213MA, FR2216A and FR2216A2
Check/adjust parking brake, FR2213MA, FR2216A, FR2216A2
Checking and adjusting of throttle wire
Clean the engine's and transmission's cooling fins
Replace the air filter's pre-filter and paper filter
Replace the fuel filter
Replace the spark plug.
1)
First change after 5 hours. When operating with a heavy load or at high ambient temperatures, replace every 25 hours.
and replace the filter more often in dusty conditions.
by authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be
!
conducted on the engine or cutting unit
unless:
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from
the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
20 –
English
Maintenance
3)
3)
2,4)
2)
3)
If the machine is used daily it should be lubricated twice a week.
Daily
Maintenance
maintenance
interval in
before
hours
starting
25 50
X
X
X
X
X
X
X
X
O
O
O
X
X X
X
X
X
X
X
X
O
O
X
X
X
O
100
X
X
X
2)
Clean
4)
Conducted