Xerox Document Centre ColorSeries 50 User Manual page 235

1
2
3
4
12
6
7
PROBLEM SOLVING
Problem
A black border appears at the edge of the
copy when a reduction option is selected.
A black border appears on the copy of a small
document.
Deletions on the copy edges.
Copies made from photographs show colour
or background on output edges
The copies made using the 100% Reduce/
Enlarge feature do not include the entire
image along the edge of the document.
Output is too light.
Output is too dark.
Output has too much contrast.
Select the Auto Shift option in the Margin Shift
feature or the Edge Erase feature of the
Added Features tab.
Select the Auto Shift option in the Margin Shift
feature or the Edge Erase feature of the
Added Features tab.
Or:
Program the Original Size in the Added Fea-
tures tab for the dark bordered document that
you wish to copy.
Edge deletion on all sides of the copy is nor-
mal, and is greatest on the lead edge of the
copy. Set the Edge Erase feature, Variable
Erase option, to 4 mm to minimize the dele-
tion. Select the size for the original document
in the Added Features tab and an appropriate
setting from the Reduce/Enlarge option from
the Basic Copying tab. Refer to the section,
"Added Features," for edge erase specifica-
tions.
Moisture may be present in the paper. Load a
fresh supply of paper into the trays.
Some deletions may be caused by small
pieces of paper remaining in the copier/printer
components after a paper jam has been
cleared. When clearing a paper jam, be sure
to look for and remove any paper fragments.
Most emulsions used to develop photographs
have colour. Sometimes this colour is shows
on the border of the photograph. To prevent
the colour from being copied as part of the
image or as background, use the Edge Erase
feature on the Added Features tab to deliber-
ately erase the unwanted colour or back-
ground from the edge.
Select the Original Size feature and program
the exact size of the dark bordered document
that you wish to copy.
Use the Lighten/Darken feature to select a
darker level. Select the Text or Graphics &
Maps option in the Original Type feature.
Use the Lighten/Darken feature to select a
lighter level. Select the Photo option in the
Original Type feature.
Select less colour (toward Pastel) Saturation
in the Image Quality tab.
3–18
Suggested Solution
DOCUMENT CENTRE CS 50 USER GUIDE