Programming Notes - Clifford Arrow 5 Installation Manual

programming notes

Note #1: Adding a new transmitter in auto-learn configuration
Press the arm/disarm button of the three-button cello remote control; the siren
will chirp once.
Immediately press arm/disarm again; the siren will chirp twice to confirm the
new transmitter has been programmed.
Note #2: Adding a new transmitter in custom-configuration
For the arm/disarm channel, transmit the channel of the new three, four, or five but-
ton transmitter that you want to control that feature; the siren will then chirp once.
Immediately transmit the same channel again, the siren will chirp twice to con-
firm the transmitter channel has been programmed.
For the rest of the channels, the siren will chirp the same number of times as the
feature row.
N N O O T T E E : : When programming a new transmitter to custom configuration, an arm/dis-
arm channel must first be programmed before programming the remaining channels.
Note #3: Selecting siren sounds
After entering this feature, press the arm/disarm button. The siren will generate a five-
second sample of each available siren sound. Perform the following steps to add or
delete that specific sound.
Personalized siren sounds require the use of a 515C in place of the standard
siren.
Add sound: Press on the PlainView 2 Valet switch while playing the desired
sound to add that sound.
Delete sound: Press
desired sound to delete that sound.
© 2004 directed electronics, inc.
on the PlainView 2 Valet switch while playing the
33