Programming Notes - Clifford Concept 450 Installation Manual

programming notes

Note #1: Adding a new transmitter in auto-learn configuration
Press the arm/disarm button of the remote control; the siren will chirp once.
Immediately press arm/disarm again; the siren will chirp twice to confirm the
new transmitter has been programmed.
Note #2: Adding a new transmitter in custom-configuration
For the arm/disarm channel, transmit the channel of the new three, four, or five but-
ton transmitter that you want to control that feature; the siren will then chirp once.
Immediately transmit the same channel again, the siren will chirp twice to con-
firm the transmitter channel has been programmed.
For the rest of the channels only one press of the button is required to learn, and
the siren will chirp the same number of times as the feature row.
N N O O T T E E : : When programming a new transmitter to custom configuration, an arm/dis-
arm channel must first be programmed before programming the remaining channels.
Note #3: Selecting siren sounds
After entering this feature, press the arm/disarm button. The siren will generate a five-
second sample of each available siren sound. Perform the following steps to add or
delete that specific sound.
Add sound: Press
sound to add that sound.
Delete sound: Press
desired sound to delete that sound.
Note #4: RPM programming
Drive the vehicle to an open area and allow the engine to warm up until the
engine RPM drops to normal idle speed.
Place the engine in park or neutral and set the parking brake.
Enter the feature and press the arm/disarm button.
The lights will flash twice to confirm the engine RPM has been learned.
N N O O T T E E : : If only one flash is seen, the engine RPM was not successfully learned. Test the
tach wire connection and retry.
Turn the ignition off and activate BlackJax or RPM door locks to test.
32
on the PlainView 2 Valet switch while playing the desired
on the PlainView 2 Valet switch while playing the
www.directed.com