Fujitsu SPARC Enterprise M4000 Features Manual page 136

DR operation canceled by operator.
[Explanation] DR operation canceled by operator
XSB#XX-X is not installed.
[Explanation] System board (XSB#XX-X) is not installed.
[Remedy] Specify the wrong XSB. Confirm the XSB by showboards(8).
XSB#XX-X is currently unavailable for DR. Try again later.
[Explanation] The specified system board (XSB#XX-X) has already been executed
by another operation.
[Remedy] DR or power-off has been executing for another session. Try again after
waiting for a while, with the confirmation of the XSB status.
XSB#XX-X has not been registered to DCL.
[Explanation] System board (XSB#XX-X) is not registered to DCL.
[Remedy] Register DCL information by setdcl(8).
XSB#XX-X is the last LSB for DomainID X, and this domain is
still running. Operation failed.
[Explanation] XSB#XX-X is the last LSB for domain#X.
[Remedy] Power-off the domain by specifying "-c reserve".
IP address of DSCP path is not specified.
[Explanation] DR cannot communicate with the domain because DSCP IP Address
is not set up or not registered.
[Remedy] Register the DSCP IP Address.
An internal error has occurred. This may have been caused by a
DR library error.
[Explanation] The DR processing cannot be failed on the domain OS. The error
occurred at the DR library.
[Remedy] Find out the cause of the DR failure referring monitoring message and
errorlog. Confirm the patch applying status and the XCP version.
DR failed. Domain (DomainID X) cannot communicate via DSCP path.
[Explanation] DR processing cannot communicate with the domain. The reasons
are that domain is powered off, the DSCP setting is wrong or the error occurs at
the DSCP path.
A-28 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • January 2012