Fujitsu SPARC Enterprise M4000 Features Manual page 100

5. Power off Domain #1 so the CMU can be replaced.
Execute the poweroff(8) command so that the CMU being replaced will not be in
use by domain #1.
XSCF> poweroff -d 1
6. Check the status of all related system boards.
Execute the showboards(8) command to display system board information, and
then check the status of all related system boards.
XSCF> showboards -a
XSB
------------------------------------------------------------------
00-0
01-0
01-1
01-2
01-3
7. Physically replace the system board.
Execute the replacefru(8) command, then follow the displayed instructions to
replace the system board per the Active Replacement procedure. For information
about Active Replacement, see the Service Manual for your server.
XSCF> replacefru
8. Check the status of the replaced system board.
Execute the showboards(8) command to display system board information, and
then check the status of the system board to be added and confirm its registration
in the DCL.
If you need to change the PSB configuration, use the setupfru(8) command. If
the system board is not registered in the DCL, register it in the DCL for the target
domain by using the setdcl(8) command.
XSCF> showboards -a
XSB
--------------------------------------------------------------------
00-0
01-0
01-1
01-2
01-3
4-18 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User's Guide • January 2012
DID(LSB) Assignment
00(00) Assigned
00(01) Assigned
00(02) Assigned
01(00) Assigned
01(01) Assigned
DID(LSB) Assignment
00(00) Assigned
00(01) Assigned
00(02) Assigned
01(00) Assigned
01(01) Assigned
Pwr Conn Conf
y y y
y n n
y n n
y n n
y n n
Pwr Conn Conf
y y y
y n n
y n n
y n n
y n n
Test Fault
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Test Fault
Passed Normal
Passed Normal
Passed Normal
Passed Normal
Passed Normal