Intel 440GX Design Manual page 116

®
Intel 440GX AGPset Platform Reference Design
82443GX Component (System bus and DRAM Interfaces)
This page shows the 82443GX component, System bus and DRAM Interfaces. The 82443GX
connects to the lower 32 bits of the CPU address bus and the CPU control signals, and generates
DRAM control signals for the memory interface. In this design, the 82443GX is configured to
interface to a memory array of 4 DIMMs for a DP design.
The CKBF is also shown on this page. The 82443GX delivers a single SDRAM clock to the CKBF
which is a 18 output buffer, with an I2C interface which may be used to disable unused clock
outputs for EMI reduction. It outputs 4 clocks to each DIMM socket, and 1 back to the 82443GX
for data timings. The last clock is used for the Global Clock Enable (GCKE) logic.
82443GX Component (PCI and AGP Interfaces)
This page shows the 82443GX component, PCI and AGP Interfaces. The definition of pin AF3 has
been changed from SUSCLK to GX-PWROK. Like PIIX4E PWROK, it is connected to the
PWROK logic from the Power Connector page (Page 32). Note the GCLKIN and GCLKOUT
trace length requirements on the AGP interface.
82443GX Component (Memory and System Data Bus Interfaces)
This page shows the 82443GX component, Memory and System Data Bus Interfaces. GTL_REF
signal are also shown on this page. Ideally, the GTL_REF signals should be decoupled separately,
and as close as possible to the 82443GX component, but this is not a requirement.
The GCKE shift register circuit is also shown.
FET Switch Component
These FET switches are used for a 4 DIMM memory configuration. 500 ohm series resistors have
been added to all of the grounded xA2 input pins.
DIMM Connectors 0, 1, 2 and 3 for the DP 4-DIMM schematics
These three pages show the DRAM interface connections from the 82443GX to the DRAM array.
The serial presence detect pins are addressed as 1010-000,001,011 respectively. 82443GX strap
pull-up/pull-downs will be located on selected MAB# lines. REGE (pin 147) on each DIMM
socket should be pulled high to enable registered DIMMs,
PIIX4E Component
This page shows the PIIX4E component. The PIIX4E component connects to the PCI bus, dual
IDE connectors, and the ISA bus. This reference design supports a subset of the power
management features of the PIIX4E.
PIIX4E Component
This page shows the PIIX4E component Interrupts, USB, DMA, power management, X-Bus, and
GPIO interfaces. Also shown is the CLOCKRUN# pull-down and the external logic needed to
handle a power loss condition.
IOAPIC Component
This sheet shows the connection for the IOAPIC controller to the various PIIX4E and processor
interrupts.
A-2
11 and 12
®
Intel 440GX AGPset Design Guide
8
9
10
13-16
17
18
19