First Time Setup; Automatic Speaker Setup (Audyssey 2Eq) - Integra DTR-5.8 Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.
Automatic Speaker Setup
(Audyssey 2EQ)
With the supplied speaker setup microphone, the
Audyssey 2EQ function can measure the number of
speakers connected, their sizes, crossover frequencies,
and the distance from each speaker to the listening posi-
tion and calculate the optimal speaker settings for your
listening environment automatically.
Before using this function, connect and position all of
your speakers.
Measurement Points
To create a listening area in which several people can
enjoy home theater simultaneously, the Audyssey 2EQ
function takes measurements at three points within the
listening area:
First measurement point
This is the center point of the listening area, or the
listening position if it's just one person.
Second measurement point
The right side of the listening area.
Third measurement point
The left side of the listening area.
The distances between points
and must be at least 1 meter.
From the examples below, choose the listening area that
best matches yours and place the microphone accord-
ingly when prompted.
TV
TV
TV
: listening area
: listening position
and and points
TV TV
TV TV
TV TV
Using Audyssey 2EQ
1
2, 9
3-8
Note: If any of your speakers is 4 ohms, change the
minimum speaker impedance setting before running
the automatic speaker setup (see page 51).
Notes:
• If the AV receiver was previously muted, it will
be unmuted.
• Automatic speaker setup cannot be performed
while a pair of headphones is connected.
• It takes about 10 minutes to complete the auto-
matic speaker setup.
1 Turn on the AV receiver and the
connected TV.
On the TV, select the input to which the
AV receiver is connected.
41