First Time Setup; Speaker Settings - Integra DTR-7.8 Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Speaker Settings

AUX 1
Game / TV
If you change these settings, you must run the auto- 4
Tape Tuner
matic speaker setup again (see page 53).
7
Phono
+10
--/--- 10
Input Selector
Macro
1
DVD
TV Cable
Dimmer
2, 3
+
CH
Disc
Album
-
1, 6
Prev
CH
Display
Rec
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
If you've connected your front speakers to the FRONT
and SURR BACK terminal posts for bi-amping, you
must change the Speaker Type setting. For hookup infor-
mation, see "Bi-amping the Front Speakers" on page 23.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
Receiver
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
Enter
The Speaker Setup menu appears.
Enter
44
AUX 2 TV CH
-
5 6
CD
8 9
TV VOL
D.TUN
0 Clear
11 12
2 3 Zone 3
Remote Mode
VCR CD Zone 2
CDR/MD
1
Dock Receiver
SAT
Tape/AMP
Sleep
2–5
Enter VOL
Muting
Playlist Random
]/[ ]
3
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [Enter].
Enter
The Speaker Settings menu appears.
2-1.Speaker Settings
Speaker Impedance
Speakers Type
Enter
4
Use the Up and Down [
buttons to select "Speaker
Impedance," and use the Left and
Enter
Right [ ]/[
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [
buttons to select "Speaker Type,"
and use the Left and Right
Enter
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp: Select this if you've con-
nected your front speakers for
bi-amped operation.
6
Press the [Setup] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
]/[ ]
6ohms
Normal
]/[ ]
] buttons to select:
]/[ ]