First Time Setup; Speaker Settings - Integra DTR-8.8 Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Speaker Settings

Game / TV AUX 1
If you change these settings, you must run the auto- 4 5
Tape Tuner
matic speaker setup again (see page 55).
7 8
Phono Net/USB
+10
0
--/--- 10
Input Selector
Macro
1 2
Remote Mode
DVD VCR
TV Cable
SAT
Dimmer
2, 3
+
CH
Enter
Disc
Album
-
1, 6
Prev
CH
Display
Rec Playlist
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
Speaker Type setting. For hookup information, see pages
25 and 26.
Notes:
• When bi-amping is used, the AV receiver is able to
feed up to 5.1 speakers in the main room.
• When bridging is used, the AV receiver is able to drive
up to 2.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
Receiver
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
Enter
The Speaker Setup menu appears.
Enter
TV CH
AUX 2
-
6
CD
9
TV VOL
D.TUN
Clear
11 12
3 Zone 3
CD Zone 2
CDR/MD/Dock
1
Net/USB Receiver
Tape/AMP
Sleep
2–5
VOL
Muting
Random
]/[ ]
3
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [Enter].
Enter
The Speaker Settings menu appears.
2-1.Speaker Settings
Speaker Impedance
Speakers Type
Enter
4
Use the Up and Down [
buttons to select "Speaker
Impedance," and use the Left and
Enter
Right [
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [
buttons to select "Speaker Type,"
and use the Left and Right
Enter
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
BTL: Select this if you've con-
nected your front speakers for
bridged operation. The BTL
indicator will appear on the
display.
6
Press the [Setup] button.
Setup closes.
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
]/[ ]
6ohms
Normal
]/[ ]
]/[ ] buttons to select:
]/[ ]
47