Equalizer Setting - Integra DTR-5.8 Instruction Manual

Advanced Setup—Continued

Equalizer Setting

This setting is set automatically by the Automatic
Speaker Setup function (see page 41).
Here you can adjust the EQ of individual speakers. To set
the volume of individual speakers see page 71.
1
2, 3
1, 8
1
Press the [Receiver] button fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
72
2-7
]/[
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
3
4
5
]
6
Use the Up and Down [
buttons to select "5. Equalizer
Settings," and then press [Enter].
The Equalizer Settings menu appears.
2–5. Equalizer Settings
Equalizer
Use the Left and Right [
buttons to select:
Off: Tone off, response flat.
Audyssey: The tone for each speaker
is set automatically by the
Automatic Speaker Setup
function.
Be sure to select this set-
ting after having per-
formed the Automatic
Speaker Setup.
Manual: You can adjust the EQ of
each speaker manually.
If you select Manual, continue with this
procedure. If you select Off or Audys-
sey, go to step 8.
Use the Down [ ] button to
select "Channel," and then use
the Left and Right [ ]/[
tons to select a speaker.
2–5. Equalizer Settings
Equalizer Manual
Channel Front
80Hz
250Hz
800Hz
2500Hz
8000Hz
Use the Up and Down [
buttons to select a frequency,
and then use the Left and Right
[ ]/[ ] buttons to adjust the
level at that frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 80 Hz)
affect bass sounds; high frequencies
(e.g., 8000 Hz) affect treble sounds.
]/[ ]
Off
]/[ ]
] but-
0dB
0dB
0dB
0dB
0dB
]/[ ]