First Time Setup; Speaker Settings - Integra DTR-7.8 Instruction Manual

First Time Setup

This section explains the settings that you need to make before using the AV receiver for the very first time.

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 53).
2, 3
1, 6
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
If you've connected your front speakers to the FRONT
and SURR BACK terminal posts for bi-amping, you
must change the Speaker Type setting. For hookup infor-
mation, see "Bi-amping the Front Speakers" on page 23.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
Receiver
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
Enter
The Speaker Setup menu appears.
Enter
44
TV CH
Game TV AUX 1 AUX 2
/
-
4 5 6
Tape Tuner CD
7 8 9
TV VOL
Phono D.TUN
+10
0 Clear
--/--- 10 11 12
Input Selector
Macro
1 2 3 Zone 3
Remote Mode
DVD VCR CD Zone 2
CDR/MD
1
TV Cable Dock Receiver
SAT
Tape/AMP
Dimmer Sleep
2–5
+
CH
Enter VOL
Disc
Album
-
Prev
CH
Display Muting
Rec Playlist Random
3
Enter
Enter
4
Enter
5
Enter
6
]/[ ]
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Use the Up and Down [
buttons to select "1. Speaker Set-
tings," and then press [Enter].
The Speaker Settings menu appears.
2-1.Speaker Settings
Speaker Impedance
Speakers Type
Use the Up and Down [
buttons to select "Speaker
Impedance," and use the Left and
Right [ ]/[ ] buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
Use the Up and Down [
buttons to select "Speaker Type,"
and use the Left and Right
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
nected your front speakers
normally.
Bi-Amp:Select this if you've con-
nected your front speakers for
bi-amped operation.
Press the [Setup] button.
Setup closes.
]/[ ]
6ohms
Normal
]/[ ]
]/[ ]