Changing The Input Display; Minimum Speaker Impedance - Integra DTR-5.6 Instruction Manual

DTR-5.6.book Page 42 Thursday, September 22, 2005 5:07 PM
First Time Setup —Continued

Changing the Input Display

If you connect an -capable Integra MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
1, 2
1 Press the [Tape] or [Video 3]
input selector button so that
"TAPE" or "VIDEO3" appears on
the display.
or
2
Press and hold down the [Tape]
or [Video 3] input selector button
(about 3 seconds) to change the
setting.
Repeat this step to select MD, CDR, or
HDD.
or
For the Tape input selector, the setting
changes in this order:
→
TAPE
For the Video 3 input selector, the set-
ting changes in this order:
VIDEO 3
Note:
HDD can be selected for the Tape input selector or
Video 3 input selector, but not both at the same time.
42
1, 2
→ → →
MD CDR HDD
↔
HDD

Minimum Speaker Impedance

Not North American models
If you change this setting, you must run the automatic
speaker setup again (see page 37).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Minimum Speaker Impedance to 4
ohms.
Note:
Before you change this setting, turn down the volume.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "3. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
3.Speaker Setup
------------------------
0.Speaker Impedance 1.Speaker Impedance
2.Speaker Configuration
3.Speaker Distance
4.Level Calibration
5.Equalizer Settings
3
Use the Up and Down [
buttons to select "Speaker
Impedance," and then press
[Enter].
4
Use the Left and Right [
buttons to select:
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Press the [Setup] button.
Setup closes.
Notes:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
]/[ ]
]/[ ]
]/[ ]