Advanced Setup; Speaker Setup - Integra DTR-5.6 Instruction Manual

DTR-5.6.book Page 63 Thursday, September 22, 2005 5:07 PM

Advanced Setup

Speaker Setup

This section explains how to check the speaker settings
and how to set them manually, which is useful if you
change a speaker after performing the automatic speaker
setup.
Some speaker settings are set automatically by the Auto-
matic Speaker Setup function (see page 37).
Receiver
Enter
Speaker Configuration
This setting is set automatically by the Automatic
Speaker Setup function (see page 37).
Here you can specify which speakers are connected and
their individual sizes.
For speakers with a cone diameter
over 6-1/2 inches (16 cm), specify
large, and for those with a diameter
below this, specify small.
1 Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
3
Setup
4
5
Cone diameter
Use the Up and Down [ ]/[
buttons to select "3. Speaker
Setup," and then press [Enter].
The Speaker Setup menu appears.
Use the Up and Down [ ]/[
buttons to select "Speaker Con-
figuration," and then press
[Enter].
The Speaker Config menu appears.
3-2.Speaker Config
------------------------
a.Subwoofer :Yes
b.Front :Large
c.Center :Small
d.Surround :Small
e.SurroundBack :Small
f.SurrBack Ch :2ch
g.Crossover :100Hz
h.Subwoofer Mode
:-------------
Use the Up and Down [ ]/[
buttons to select "a. Subwoofer,"
and then use the Left and Right
[ ]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
Use the Up and Down [ ]/[
buttons to select "b. Front," and
then use the Left and Right
[ ]/[ ] buttons to select:
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 4 is
set to No, this setting is fixed at
Large.
]
]
]
]
63