Integra DTR-5.6 Instruction Manual page 64

DTR-5.6.book Page 64 Thursday, September 22, 2005 5:07 PM
Advanced Setup —Continued
6
Use the Up and Down [
buttons to select "c. Center," and
then use the Left and Right
[ ]/[
Small: Select if the center speaker is
Large: Select if the center speaker is
None: Select if no center speaker is
Note:
• If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
7
Use the Up and Down [
buttons to select "d. Surround,"
and then use the Left and Right
[ ]/[
Small: Select if the surround left and
Large: Select if the surround left and
None: Select if no surround left and
Note:
• If the Front setting in step 5 is set to
Small, the Large option cannot be
selected.
8
Use the Up and Down [
buttons to select "e. Surround-
Back," and then use the Left and
Right [
Small: Select if the surround back
Large: Select if the surround back
None: Select if no surround back
Notes:
• If the Surround setting in step 7 is set
to None, this setting cannot be
selected.
• If the Surround setting in step 7 is set
to Small, this setting cannot be set to
Large.
64
]/[ ]
] buttons to select:
small.
large.
connected.
]/[ ]
] buttons to select:
right speakers are small.
right speakers are large.
right speakers are connected.
]/[ ]
]/[ ] buttons to select:
left and right speakers are
small.
speakers are large.
speakers are connected.
9 Use the Up and Down [
buttons to select "f. SurrBack
Ch," and then use the Left and
Right [ ]/[
1ch: Select if one surround back
speaker is connected.
2ch: Select if two (left and right)
surround back speakers are
connected.
Continue with step 10 in the next col-
umn.
Crossover
10
Use the Up and Down [
buttons to select "g. Crossover,"
and then use the Left and Right
[ ]/[ ] buttons to select a
crossover frequency.
Choose a crossover frequency suitable
for your setup. If you're using a sub-
woofer, choose a crossover frequency
based on the diameter of your front
speakers. If you're not using a sub-
woofer, use the diameter of any speaker
that you specified as Small.
Speaker cone
diameter
Over 12 in.
(20 cm)
6-1/2 to 8 in.
(16–20 cm)
5-1/4 to 6-1/2 in.
(13–16 cm)
3-1/2 to 5-1/4 in.
(9–13 cm)
Under 3-1/2 in.
(9 cm)
Continue with step 11 on the next page.
Note:
• If the crossover frequency is set to a low value, and the
program material doesn't contain any sounds below
that frequency, the subwoofer will not output much
sound.
]/[ ]
] buttons to select:
]/[ ]
Crossover
frequency
60Hz
70Hz
80Hz
90Hz
100Hz
110Hz
120Hz
130Hz
150Hz
200Hz