Digital Input Signal Formats - Integra DTR-5.6 Instruction Manual

DTR-5.6.book Page 72 Thursday, September 22, 2005 5:07 PM
Advanced Setup —Continued

Digital Input Signal Formats

Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can specify the signal format as either PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or rewind-
ing a DTS CD, try the DTS setting.
Receiver
Enter
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Digital
Input," and then press [Enter].
72
3
4
Setup
5
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
]/[ ]
Use the Up and Down [ ]/[
buttons to select an input source
that's assigned to a digital input
(opt or coax), and then press
[Enter].
The Digital Format menu appears.
2-1.Digital Format
------------------------
a.DVD :Auto
b.VIDEO1 :Auto
c.VIDEO2 :----
d.VIDEO3 :Auto
e.VIDEO4 :Auto
f.TAPE :----
g.CD :Auto
Use the Up and Down [ ]/[
buttons to select the input, and
use the Left and Right [ ]/[
buttons to select: PCM, DTS, or
Auto.
PCM: The PCM indicator flashes, and
only input signals in PCM format will
be output.
DTS: The DTS indicator flashes, and
only input signals in DTS format will
be output.
Auto (default): The format is detected
automatically. If no digital input signal
is present, the corresponding analog
input is used instead.
Press the [Setup] button.
Setup closes.
]
]
]