Listening To Am/Fm Radio - Integra DTR-70.3 Instruction Manual

Using Remote Playback
1
Start Windows Media Player 12.
To enable remote playback, you must first configure
Windows Media Player 12.
2 Press NET.
The "NET" screen appears. The NET indicator
lights. If it flashes, verify the network connection.
3
Use / / /
A list of media server appears.
Note
• Remote playback cannot be used while the music files of
another media server are being played. You must stop their
playback first.
4
On Windows Media Player 12, right-click on a
music file.
The right-click menu appears. For selecting another
media server, select the desired media server from the
"Other Libraries" menu on Windows Media Player
12.
5
Select the AV receiver from the right-click menu.
The "Play to" window appears and playback on the
product starts. Operations during remote playback
can be made from the "Play to" window of Windows
7 on your personal computer. During remote
playback, operations (such as Playback, Pause, Fast
Forward, Fast Rewind, Previous, Next, Repeat,
Random) cannot be made.
6
Adjusting the Volume
You can adjust the volume by adjusting the volume
bar in the "Remote playback" window. The default
maximum volume level is 82 (0dB). If you wish to
change this, enter the value from the Web Setup in
your browser.
The volume value of the remote window and the
volume value of the AV receiver may not always
match.
Adjustments you make to the volume in the AV
receiver will not be reflected in the "Remote
playback" window.
En
28
to select "dlna", and press Enter.

Listening to AM/FM Radio

This section describes the procedure using the
buttons on the front panel unless otherwise specified.
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps
1
Press Tuner to select either "AM" or "FM".
In this example, FM has been selected.
Each time you press Tuner, the radio band changes
between AM and FM.
Band Frequency
(Actual display depends on the country.)
Tuning into Radio Stations
■
Auto tuning mode
1
Press Tuning Mode so that the AUTO indicator
lights on the display.
2
Press Tuning / .
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights on the display, as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
1
Press Tuning Mode so that the AUTO indicator
goes off on the display.
2
Press and hold Tuning / .
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
(➔ page 64).
TUNED
AUTO
FM STEREO