Listening To The Am/Fm Radio - Integra DTM-7 Instruction Manual

> Before Start > Part Names

Listening To the AM/FM Radio

1
You can receive FM and AM radio stations
on this unit with the built-in tuner. Perform
the following procedure when the unit is on.
∫ Tuning into a Radio Station
Tuning Automatically
1. Repeatedly press Tuner (a) on the
remote controller and select "AM" or
"FM".
2. Press Tuning Mode on the main unit so
that "TunMode:Auto" appears on the
display.
3. When you press the cursor D/C
buttons (b) on the remote controller,
automatic tuning starts, and searching
stops when a station is found. When
tuned into a radio station, the "TUNED"
indicator on the display lights. When
tuned into a stereo FM radio station, the
> Install > Initial Setup
2
"FM ST" indicator lights.
When FM broadcasts reception is poor:
Perform the procedure for "Tuning
Manually" in the following section. Note
that if you tune manually, the reception for
FM broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
Tuning Manually
If you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Repeatedly press Tuner (a) on the
remote controller and select "AM" or
"FM".
2. Press Tuning Mode on the main unit so
that "TunMode:Manual" appears on the
display.
> Playback
Advanced Setup | Supplementary Information | Others
3
3. While pressing the cursor D/C buttons
(b) on the remote controller, select the
desired radio station.
0 The frequency changes by 1 step
each time you press D/C. The
frequency changes continuously if the
button is held down and stops when
the button is released.
Frequency step setting:
Press Setup on the remote controller, then
use the cursor buttons and Enter on the
remote controller to select "7.
Miscellaneous" - "Tuner" - "AM / FM
Frequency Step", and select the frequency
step for your region. Note that when this
setting is changed, all radio presets are
deleted.
a
b
d
c
En
25