Igniting The Burners - CDA HVG620 Manual For Installation, Use And Maintenance

Igniting the Burners

The hob is fitted with a flame failure device. Flame failure devices
operate by shutting off the supply of gas to the burner in the event
that the flame is extinguished accidentally.
To ignite the burners, follow these
instructions:
1. Lightly press the control knob down
and turn the knob anticlockwise to the
maximum position. Firmly press and
hold down the control knob to begin
the ignition process (a clicking sound
will be heard). Hold down the control knob for a few seconds after
ignition to allow the safety device to detect that the burner is lit.
2. Once the burner is lit, adjust the burner power to the required
position.
The hob is fitted with a flame failure device. Hold down the control
knob for a few seconds after ignition to allow the safety device
to detect that the burner is lit. Flame failure devices operate by
shutting off the supply of gas to the burner in the event that the
flame is extinguished accidentally.
Please note:
• The ignition device should not be operated for more than 15
seconds.
6
fig. 2