Table of Contents
Advertisement
How to Install the Hob
How to install the hob:
Overall hob dimensions:
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Note that before doing this,
check the instructions supplied with any cooker hood to ensure that
you will have the required clearance. The cut-out (Fig 6) shows a
61.5mm gap from the wall to the cut-out edge. The distance for the
hob, when fitted, to the back wall is 50mm.
2. Position the hob seal, as shown in the diagram below (Fig 8),
ensuring that the ends meet without overlapping. Do not use
silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig 9).
Remove any excess sealant after tightening the brackets.
185mm
150mm
Fig.6
Fig.8
>61.5mm
477mm
560cm
557mm
185mm
150mm
Fig.9
HVG620 = 580mm (W) x 500mm (D)
HVG720 = 700mm (W) x 510mm (D)
557mm (W) x 477mm (D)
Fig.7
3cm
4cm
17
Advertisement
Table of Contents
