Table of Contents
Advertisement
Gas burners
Gas flow to the burners is controlled by the control knobs (5, 6, 7 and
8 in Fig. 1). There are 3 positions shown on the control panel (Fig. 2).
Turning the control knob to the positions shown below achieves the
following:
Closed (switches gas valve and burner off)
Maximum position (highest heat level) & ignition
position
Minimum position (lowest heat level)
The knobs should always be turned in an anticlockwise (left) direction
from the closed/off position. Attempting to ignite the burner in a
clockwise direction from the closed position may cause damage to
the hob.
Igniting the gas burners
This hob's burners are fitted with flame failure devices. These
operate by shutting off the gas supply to the burner in the event
that the flame is extinguished whilst the control knob is in an open
position.
To ignite the burners
Press the control knob down and turn the knob anticlockwise (left)
to the maximum position. Hold the control knob down to begin the
ignition process (a constant clicking should be heard). Once the
flame appears around the burner, keep the control knob pressed
7
Advertisement
Table of Contents
