Fuel Conversion - Jøtul GF 400 BV Sebago Installation And Operation Instructions Manual

Fuel Conversion

The Jøtul GF 400 BV gas stove is shipped from the factory
equipped to burn NATURAL GAS only. If PROPANE gas is to
be used as fuel, the appliance must first be converted for
use with propane. Use Propane Conversion Kit 156005,
supplied with the appliance.
Order and install NG Conversion Kit 156006 to change
back to use with natural gas.
WARNING:
THE CONVERSION KIT IS TO BE INSTALLED BY
AN AUTHORIZED JØTUL SERVICE TECHNICIAN
IN ACCORDANCE WITH THE MANUFACTURER'S
INSTRUCTION AND ALL CODES AND REQUIRE-
MENTS OF THE AUTHORITY HAVING JURISDIC-
TION. FAILURE TO FOLLOW THESE INSTRUC-
TIONS COULD RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE. THE QUALIFIED AGENCY
PERFORMING THIS WORK ASSUMES RESPON-
SIBILITY FOR THIS CONVERSION.
IN CANADA:
THE CONVERSION SHALL BE CARRIED OUT IN
ACCORDANCE WITH THE REQUIREMENTS OF
THE PROVINCIAL AUTHORITIES HAVING JURIS-
DICTION AND IN ACCORDANCE WITH THE
REQUIREMENTS OF THE CAN1-B149.1 AND .2
INSTALLATION CODE.
AVERTISEMENT:
Cet equipement de conversion sera installe
par une agence qualkfiee de service
conformenment aux instructions du fabricant
et toutes exigences et codes applecables de
l'autorises avoir la juridiction. Si l'informaiton
dans cette Instruction n'est pas suivie
exactement, un feu, explosion ou production
de protoxyde de carbone peut resulter le
dommages causer de propriete, perte ou
blessure personnelle de vie. L'agence
qualifiee' de service est esponsable de
l'installation propre de cet equipement.
L'installation n'est pas propre et complete
jusqu'a l'operation de l'appareil converti est
cheque suivant les criteres etablis dans les
instructions de proprietaire provisionnees
avec l'equipement.
T T T T T ools r ools r ools r equir equir ed: ed:
ools r ools requir equired: equir ed: ed:
• 1/2" open ended wrench or deep-well socket, Torx T20
or slotted screwdriver, 4 mm allen wrench.
Conversion Kit Contents:
• 1, regulator tower labeled for propane
• 3, regulator tower screws
• 1, burner orifice (3.20 mm for NG, #49 for LPG)
• 1, pilot orifice (#51 for NG, #30 for LPG)
• Label A - to be completed and applied to
the back of the stove
• Label B - apply to the stove's Rating Plate
• Small valve label - apply to valve body
Conversion instructions are also shipped in the stove with
the conversion kit.
Fuel Conversion Procedure
1. Turn off gas supply to stove.
2. Remove the stove Top Plate.
3. Disengage the two Glass Frame Latches at the top of
the firebox. See illustration on page 5. Carefully lift the
glass panel up and out of the stove.
4. If installed, remove the Embers and Log Set using care
not to damage the fragile log parts.
5. Lift out the Burner Skirt shown in fig.11.
6. Reach under the stove and remove the Air Shutter
wingnut from its stud. See fig. 12.
Burner Skirt Burner Skirt Burner Skirt Burner Skirt Burner Skirt
Figure 11. Lift and remove the Burner Skirt from within the
firebox.
Insulation Pad
Fender Washer
Wi
Figure 12. Locate and remove the Air Shutter wingnut from
under the right side of the stove.
t
11