General Information - Jøtul GF 400 BV Sebago Installation And Operation Instructions Manual

General Information

THIS HEATER MUST BE INSTALLED AND MAINTAINED
BY A QUALIFIED SERVICE AGENCY.
The installation and repair of this appliance must be
done by a qualified service person. Failure to properly
install and maintain this heater could result in an
unsafe or hazardous installation, which may result in a
fire, explosion, property damage, personal injury or loss
of life.
This appliance may be installed in an aftermarket
permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type(s) of gas
indicated on the rating plate. This appliance is not
convertible for use with other gases, unless a certified
kit is used.
Cet appareil peut être installé dans un maison
préfabriquée (mobile) déjà installée à demeure si les
règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les
types de gas indiqués sur la plaque signalétique. Ne
pas l'utiliser ave d'autres gas sauf si un kitde conver-
sion certifié est installé.
This appliance should be inspected before use and at
least annually. More frequent cleaning may be
required due to excessive lint from carpeting, bedding
material, etc. It is imperative that control compart-
ments, burners, and circulating air passageways of the
appliance be kept clean.
THIS APPLIANCE MUST NOT BE CONNECTED TO A
CHIMNEY OR FLUE SERVING ANY OTHER APPLIANCE.
The installation must conform to local codes. Your
local Jøtul dealer can assist you in determining what is
required in your area for a safe and legal installation.
Some areas require a permit to install a gas burning
appliance. Always consult your local building inspector,
or authority having jurisdiction, to determine what
regulations apply in your area.
CODE COMPLIANCE: Your local officials have final
authority in determining if a proposed installation is
acceptable. Any requirement that is requested by the
local authority having jurisdiction, that is not specifi-
cally addressed in this manual, defaults to local code.
In the absence of local codes, the installation require-
ments must comply with the current edition of
National codes. In the U.S., these requirements are
established in the National Fuel Code, ANSI
Z223.1.(NFPA 54) current edition. In Canada, the codes
have been established in CAN/CGA B149 Fuel Installa-
tion Code, current edition.
Consult the local or national installation code(s) to
assure that adequate combustion and ventilation air is
available.
Installer l'appareil selon les codes ou reglements locaux,
ou, en l'absence de tels reglements, selon les Codes
d'installation CAN/CGA-B149.
DO NOT OPERATE THIS STOVE IF ANY PART HAS BEEN
UNDER WATER. Call a qualified service technician to
inspect the heater and to replace any part of the
control system and any gas control which may have
been under water.
Ne pas se servir de cet appareil s'il a ete' plonge dans
l'eau, completement ou en partie. Appeler un technicien
qualifie pour inspecter l'appareil et remplacer toute
partie du syste'me de controle et toute commande qui
ont ete plonges dans l'eau.
Glass Panel
Do not operate this appliance with the glass front
removed, cracked, or broken. Replacement of the
glass should be done by a licensed or qualified
service person. Only remove glass for routine
service. Always handle glass carefully.
Unpacking your stove
1. Remove the Top Plate of the stove by simply lifting it
straight off of the stove body.
2. To open the firebox, disengage the two Glass Frame
Latches located on top of the firebox. Pull each handle
forward to clear the latch from the notch in the frame.
3. Familiarize yourself with the installation requirements
specified in this manual, before beginning the installa-
tion.
Hardware Bag Contents
• Fuel Conversion Kit - LP .................................. 156005
• Decorative Pipe Mounting Brackets (4) ..... 129469
Glass
Frame
Latch
5