Toshiba RAS-M16PKVP-E Service Manual page 80

10-3-5. Piping and Drain Hose Installation
K Piping and drain hose forming
Since condensation results in machine trouble,
make sure to insulate both the connecting pipes
separately.
(Use polyethylene foam as insulating material.)
Rear right
Rear left
Bottom left
Left
Bottom right
Right
Fig. 10-3-10
K Relocating drain hose
For left connection, left-bottom connection and
rear-left connection's piping, it is necessary to
relocate the drain hose and drain cap.
1) Cutting front panel slit.
Cut out the slit on the left or right side of the
front panel for the left or right connection and
the slit on the bottom left or right side of the
front panel for the bottom left or right connec-
tion with a pair of nippers.
2) Remove the drain cap
Clamp drain cap with needle-nose pliers, and
pull out.
Fig. 10-3-11
3) Remove the drain horse
The drain hose is secured in place by a screw.
Remove the screw securing the drain hose,
then pull out the drain hose.
Screw
Fig. 10-3-12
Drain hose
– 80 –
4) Attach the drain cap
• Insert hexagonal wrench (4 mm).
4 mm
Fig. 10-3-13
5) Firmly insert drain cap.
No gap
Insert a hexagon
wrench (Ø4mm)
Fig. 10-3-14
6) Attach the drain hose
Insert the drain hose firmly until the
connector contacts with the insulation, then
secure it in place using the original screw.
Always use the original screw that se-
cured the drain hose to the unit. If using a
different screw may cause water to leak.
CAUTION
Securely insert the drain hose and drain cap;
otherwise, water may leak.
NOTE
The packaged foam polystyrene can
be used to make replacement of the
drain cap and drain hose easier.
K Piping on the right side or the left side
• After making slits on the front panel with a
knife or similar tool, cut them out with a pair of
nippers or an equivalent tool.
Slit
Fig. 10-3-15
Do not apply lubricating oil
(refrigerant machine oil)
when inserting the drain cap.
If applied, deterioration and
drain leakage of the drain
plug may occur.
Unit
Foam polystyrene
of package