Toshiba RAS-M16PKVP-E Service Manual page 135

No. Part name
1. Removal of defective compressor
Compressor
9
assembly
1) Perform work of Detachment 1 of
2) Recover the refrigerant gas from the outdoor
3) Perform works of
4) Remove the soundproof plate and TD sensor.
5) Take off fixing screw for the anchor board and
6) Take off fixing screws for the anchor board
7) Take off fixing screws for the anchor board
8) Using a burner, remove the welded parts
NOTE)
Take care that the electric parts, sensors,
compressor, and etc. are not caught by flame.
(Otherwise operation trouble may occur.)
9) Pull out the refrigerating cycle upward.
NOTE)
Pull out the refrigerating cycle by two or more
persons.
10) Take off the compressor bolts (3 pcs.) which
11) Remove the compressor from the compres-
NOTE)
A compressor weighs approx. 15kg.
Treat a compressor by two or more personals.
Caution to assemble compressor
Procedure
unit.
2 , 3
the partition plate. (ST1T Ø4 × 8, 1 pc.)
and the heat exchanger.
(ST1T Ø4 × 8, 2 pcs.)
and the valve fixing plate.
(ST1T Ø4 × 8, 2 pcs.)
(discharge pipe, suction pipe) connected to
the compressor.
fix the compressor to the compressor fixing
plate.
sor fixing plate.
• Tighten the compressor bolt with 5N•m
(50kgf•cm).
• Be sure not to burn lead wire of the coil.
• Take care there is no missing of sensor.
.
1
and 4 .
– 135 –
Remarks
Partition plate
Valve
fixing plate
Compressor
Discharge pipe Discharge pipe Discharge pipe
(Take off) (Take off) (Take off)
Suction pipe Suction pipe Suction pipe
(Take off) (Take off) (Take off)
Compressor Compressor
Mount the soundproof plate by
passing between the compressor
and pipes and between pipes and
the partition plate in order of
upper, inner, outer and rear sides.
Soundproof plate Soundproof plate Soundproof plate
(Upper) (Upper) (Upper)
Soundproof plate Soundproof plate Soundproof plate Soundproof plate
(Outer) (Rear) (Rear) (Rear)
Soundproof plate Soundproof plate Soundproof plate
(Inner) (Inner) (Inner)